Journal of Aeronautics & Aerospace Engineering
Open Access

Abstract

A New Methodology for Aerodynamic Design and Analysis of a Small Scale Blended Wing Body

Baig AZ, Cheema TA, Aslam Z, Khan YM, Sajid Dar H and Khaliq SB

The blended wing body (BWB) concept is a relatively new concept of an aircraft. The wings and the fuselage blend into one integral structure greatly reduce drag and increases lift thus making it a highly efficient design. The aim of the research was to design a radio controlled small scale BWB aircraft for use over long ranges at low altitudes in order to deliver payloads. The BWB was divided into the center body and the outer wing. Four airfoils, HS522, LA2573A, NACA 25111 and MH78 were analyzed in XFLR5. In consideration of their lift and moment characteristics, NACA 25111 and MH78 were selected for the center body and the wing respectively. The stall speed and wing loading were the primary factors used in determining the area and size of the aircraft which converged to a design having a five feet wingspan. Center of gravity was placed ahead of aerodynamic center to provide static and dynamic stability in pitch. Twist, dihedral and sweep were given to increase stability and controllability. The final design was tested in XFLR5 for stability and in commercial computational fluid dynamic code ANSYS-Fluent for comparison. These simulation results were compared to wind tunnel tests of a 20% scaled down prototype. 3D Panel Method results in XFLR5 were found to be very close to wind tunnel results but CFD results were seen to be not conforming to the wind tunnel results after 10° angle of attack. Thus, CFD was deemed to be unnecessary for designing a plane of this size. Ultimately, a larger test prototype was made out of polystyrene foam and a successful flight was achieved.